page2/5

　

　

M-CAR-fig10.jpg (67565 バイト) (fig 10 )

M-CAR-fig11.jpg (48897 バイト) (fig 11 )

The way to make of the front fender.

Display a only front fender layers .
Insert a line in the middle the line of the frame is cut with an intermediate line.
Create some line on space with Crv2View command corresponding to 1-3, 2-3, 6-4, 6-5. (fig 10 )(fig 11 )

　

M-CAR-fig12.jpg (57727 バイト) (fig 12 )

Decrease the control points of the line, where was possible with a Rebuild command the line is adjusted
by using the movement of the control points and
Combine the edge of the line by using a Match command. (fig 12 )

　

M-CAR-fig13.jpg (61521 バイト) (fig 13 )

Create face of an oblong is made to the middle and
Make the point of intersection of the line and face with an Intersect command and
Make a section line that it passes the 4 points . (fig 13 )

　

M-CAR-fig14.jpg (83096 バイト) (fig 14 )

Create a surface from a curve with a NetworkSrf command. (fig 14 )

　

M-CAR-fig15.jpg (54909 バイト) (fig 15 )

The way to make of the trunk.

Display a only trunk layers .
Create intermediate line 1 and make a line on space using line 1 and line 2 with a Crv2View command. (fig 15 )

　

M-CAR-fig16.jpg (58413 バイト) (fig 16 )

Make 2 section lines As it touches to the edges of other lines. (fig 16 )

　

M-CAR-fig17.jpg (80832 バイト) (fig 17 )

Create a surface from a curve with a NetworkSrf command. (fig 17 )

　

M-CAR-fig18.jpg (56922 バイト) (fig 18 )

Make a face even a rear fender as the same as a front fender. (fig 18 )

　

　

NEXT

HOME      BACK